Canmove, confirm
432
edits
Changes
m
→Reflashing
# Make sure Oban board is physically connected with USB, and has booted up.
# Press and hold the FRC button, then press and hold the RST button, then release RST, then release FRC. (These buttons are on the corner of the board by power switch.)
# If this is the first time you've done this, wait for Windows to prompt for installing a new device (if you're running in VMWare, make sure the "NVidia APX" USB device is connected to the VM). Don't do the Windows "automatic" install -- select the "have a disk" / "specific location" option and point it at the driver you downloaded ion step 1. After you've installed this driver oneonce, you won't have to install it again when flashing in the future.
# Open up the folder from the unzipped OS image.
# Double-click the "nvflash_oban_nokitl.bat" icon to run the flasher.
# You should see a bunch of output and progress in the console that opens. Takes less than a minute to finish.
# The device will reset itself, and boot into the updated OS. Done!
